smalltime
New Member
crackin 10 sec zone
Posts: 24
|
Post by smalltime on Sept 11, 2014 10:37:50 GMT -5
I need some immediate help. I recently built a SBC 400 and it has the starter bolts that are angled/horizontal with each other. The starter rocks when it engages with the flyweel. I need an immediate solution to this. If the motor doesn't start immediately and the compression kicks in, it rocks the starter and the bendix gears collide with the flywee.. 911 HELP NOW
|
|
|
|
Post by sg3526 on Sept 11, 2014 16:49:11 GMT -5
They make a bracket that bolts onto the starter (top endcap bolt should have a little stud sticking off it) and that bolts to the block. It is designed to help keep the starters from rocking when you crank the motor. Not sure but I may have a few of them laying around.
|
|
|
|
Post by blackandblueracing on Sept 14, 2014 20:27:15 GMT -5
I bought the powermaster starter with staggered ans straight and used all 3 bolts on my 400. I had the same problem till I bought that.
|
|
Bujang Lah Kau kagak ada btol
